How to Install External Corners Using Fibre Cement Moulds in Adelaide Homes

Installing external corners on fibre cement cladding is an essential part of getting a clean, weatherproof finish — especially in South Australian conditions where heat, wind, and storms can test your build. Whether you're a builder in Adelaide or a DIY renovator in the Hills, fibre cement moulds and joiners offer a reliable solution for long-lasting external corners.

Why External Corner Moulds Matter

Without properly sealed and supported corners, water can seep behind your cladding, leading to warping, mould, and structural issues. External corner moulds and angles create a tight finish, improve visual appeal, and add essential protection to the weakest points of a cladding system.

Types of External Corner Trims for Fibre Cement

At PPC Fibre Cement, we stock a wide range of external trims to suit different cladding profiles, thicknesses, and finishes:

Step-by-Step Guide to Installing External Corners

  1. Measure and cut your fibre cement boards, allowing a gap per manufacturer specs for movement.
  2. Attach the corner mould to your framing using approved fasteners (typically class 3 screws).
  3. Fit the boards snugly into the mould and seal with an NCC-compliant gap filler or sealant.
  4. Check alignment before proceeding with fixings to ensure straight, plumb edges.
  5. Apply a finishing coat if required, especially when using exposed trims or raw aluminium.

Be sure to follow NCC guidelines and refer to the relevant James Hardie or BGC installation manuals for best results.

Tools & Accessories You’ll Need

Delivered Across Adelaide and Regional SA

We offer same-day delivery for in-stock corner trims and accessories across metropolitan Adelaide, with fast turnaround on regional orders.

Shop all external trims and fibre cement accessories »

Back to blog